ExpeditionExpedition Navigation Software

You are not logged in. Would you like to login or register?



9/14/2021 8:50 am  #1


Damping

I found my sail choses on the route display to be incorrect. It was blowing 28 kts that day and noticed Expedition had picked a chute to be 1/2 oz for the downwind leg and the #1 for upwind leg when it should have been the S4 and the J3. I think I dampen my numbers to keep relistic too much. Where do I find the place to dampen it and are there any other adjustment that I should also check? Thanks for your time!!!!  

 

9/14/2021 11:35 am  #2


Re: Damping

Expedition's channels settings page.

 

9/15/2021 6:20 pm  #3


Re: Damping

Ok, went thru the Channels:
TWA- 30
TWD-60
Next Mark TWA- 30
MarkTWA- 30
TWS-30
Current- 60
Set-60
rest set to zero
I am assuming these damping % s are too high. Should I put them to zero or 10%, I don't know what to do here. I just know the numbers dampen are too high and incorrect sails are beiing chosen incorrectly. I am on a fresh water lake. Why are the drift and set  at 60? Looking for advice, Thanks.  

     Thread Starter
 

9/15/2021 7:27 pm  #4


Re: Damping

Normally TWD & TWS would be damped up to 10s, depending in the instrument systems.

Set & drift generally need longer dampings as they can be noisy, again depending on the instruments.

I wouldn't normally damp much else.

 

Board footera

 

Powered by Boardhost. Create a Free Forum




Check out RaceData for iOS and Android. Expedition data in the palm of your hand, or on your wrist! RaceData

Interested in advertising here? Over one thousand active navigators and Expedition users visit this forum. Click here to contact the administrator.