Expedition Navigation Software You are not logged in. Would you like to login?
NOTICE: Registration on the Expedition Forum has been temporarily disabled due to spam activity. If you need to register please contact the administrator.
1 of 1- smokeseattle
- Expert
Offline - From: Seattle Wa
- Registered: 5/25/2017
- Posts: 19
No position or AIS data in Expedition connection after 11.8.6
Hello,
After updating to 11.8.6 I have lost position and AIS data on my on-deck tablet connected to the boat PC via an Expedition UDP connection. Data channels come through correctly but that is it. I can't find any relevant options that got switched. Boat PC has AIS and position data being received normally.
Hoping it's a simple fix or oversight on my side, does anyone has a similar issue?
Thank you,
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 3,010
Re: No position or AIS data in Expedition connection after 11.8.6
What is the instrument data type? If it is the Expedition format, that won't send AIS data.
- smokeseattle
- Expert
Offline
- From: Seattle Wa
- Registered: 5/25/2017
- Posts: 19
Re: No position or AIS data in Expedition connection after 11.8.6
Thank you for the quick reply Nick,
Understood on the AIS, I Will try to set up a UDP broadcast from the AIS com port.
I am using an expedition data type UDP network connection, sending and receiving numeric channel data but no position data is being received by the tablet. I was getting position data when I tested it before updating.
Is there a specific RX/TX channel selection needed to get it to pass position data via the Expedition data connection?
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 3,010
Re: No position or AIS data in Expedition connection after 11.8.6
Yes, you can tell Exp which data to send. Check that you have lat & lon selected