Expedition Navigation Software 
1 of 1- DuncanR
- Expert
Offline - From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Ping marks H5000 and Expedition
Maybe this can be done, but I don't think so. Someone lead me to the light if it can
.
If you have B&G5000, a B&G Graphic Display and an MOB button linked to B&G, pressing the MOB button changes the graphic display to MOB screen, and puts an MOB position into Expedition, thereby changing Expedition's Mark Range and Bearing data to the MOB position.
What I'd like is to be able to interchange start marks information between the graphic display and Expedition when pinged. I don't much care on which technology the ping is initiated.
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 3,102
Re: Ping marks H5000 and Expedition
If you have the Send Start events option enabled, Exp should send the ends when you ping them to the H5, similarly to the timer.
If you don't have the option selected, Exp will accept data from the H5.
- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Re: Ping marks H5000 and Expedition
Damn fine, will try tomorrow. Still caught between the programming world of WTPs and the point n' shoot world of H5000. When will opensource WTP4 arrive?
- •
Thread Starter- troach
- Member
Offline
- Registered: 9/23/2020
- Posts: 2
Re: Ping marks H5000 and Expedition
I have a H5000 feeding Expedition via the websocket. Expedition is receiving the starting timer from the websocket but I cannot get expedition to receive the starting line pings. I have the checkbox unchecked for send start events else receive. Do I need to add some thing to H5000 config file to make this work? Or....
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 3,102
Re: Ping marks H5000 and Expedition
Expedition will only receive the line ends if you set Exp to not send them to H5000.
- troach
- Member
Offline
- Registered: 9/23/2020
- Posts: 2
Re: Ping marks H5000 and Expedition
I have that checkbox unchecked, Expedition receives the timer but not the start line ends
- JohnA
- Expert
Offline
- Registered: 2/06/2017
- Posts: 29
Re: Ping marks H5000 and Expedition
Any updated information as to sending H5000 start mark pings to Exp over Websocket?
For me with Exp v12.1.14 and h5000 Hercules;
Exp to H5000 works for Start timer and Pings.
H5000 to Exp works only for the start timer.
Exp help suggests: "Start line ends set from a GFD or MFD may not be sent by the processor".
I have tried pinging with GFDs and Zeus3. None was sent to Exp.
Are there some SW/FW/HW revision issues here? Or must it be concluded that it simply does not work?
Any help or suggestions welcome!