Expedition Navigation Software 
1 of 1- CAG
- Member
Offline - Registered: 7/11/2022
- Posts: 2
Routing - incomplete Route within grib period of grib
Why would my routing stop half way around the course? It is a 600nm course that should take around 4 days. I am using GRIBS from GFS Expedition/GFS 0.25 with a Runtime of 13 days. Invariably, when I optimise the model only runs for 90 hours and only shows me the first 430nm of the route. What could be the reasons for that? There is no error message. The end of the course is in deep water. Software updated yesterday. Installation yesterday of Winning Tides for the start of the route. What shiould I be checking for?
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,969
Re: Routing - incomplete Route within grib period of grib
The paths is always a good option to see what is happening.
- CAG
- Member
Offline
- Registered: 7/11/2022
- Posts: 2
Re: Routing - incomplete Route within grib period of grib
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,969
Re: Routing - incomplete Route within grib period of grib
Maybe email me with details. It is hard to see from that.
- Campbell_Field
- Moderator
Offline
- From: UK
- Registered: 9/16/2015
- Posts: 238
Re: Routing - incomplete Route within grib period of grib
Looks like a complicated routing with all the TSS marks as rounding marks.
Try just rounding the rock, with no restrictions on the race note TSS.
If it runs fine, then maybe start to add restrictions.
:::Campbell Field::::::www.fieldyachting.com:::