Expedition Navigation Software 
1 of 1- DuncanR
- Expert
Offline - From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Sydney-Noumea Yacht race YB Tracker
snyr2018 is what I have, "Requested URL not found". Has anybody else tried and succeeded?
- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Re: Sydney-Noumea Yacht race YB Tracker
Yeah, that works fine. Maybe they haven't triggered it yet, as you say. I'd prefer the S to N than the A to N run.. they are going to spend lots of time looking at jobs.
- •
Thread Starter- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Re: Sydney-Noumea Yacht race YB Tracker
Stop press. YB changed the link id, new link will go out to boats on tonight's radio sched 2030 hrs AEST, we may know after that.
I tried to guess, but haven't got it .....
- •
Thread Starter- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
- •
Thread Starter- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Re: Sydney-Noumea Yacht race YB Tracker
Nick, just playing around with Expedition open and YB Tracker set to the above race. The S-N YB race tracker updates every 10 minutes.
I notice that this spontaneously updates itself in my Expedition sometimes, without my intervention via Sail/YB Tracking etc. But it also does not update itself every 10 minute cycle, just some times. Any guesses?
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 3,000
Re: Sydney-Noumea Yacht race YB Tracker
See the Expedition Scheduler for setting the download frequency.
- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 471
Re: Sydney-Noumea Yacht race YB Tracker
OK Nick, you win, I didn't think of that. Does this create a pull if you have an active internet connection, and a race and boats set up in Expedition YB tracker i.e. does it stop you from having to manually update?
Cheers
- •
Thread Starter
DuncanR wrote: