ExpeditionExpedition Navigation Software

You are not logged in. Would you like to login or register?



  • Index
  •  » Technical Q&A
  •  » Deckman and CMAP MAX 4D

    • 1 of 1

     

    1/21/2018 2:22 pm  #1

    DuncanR
    Expert

    Offline

    From: Up and down East Coast Aus
    Registered: 9/16/2015
    Posts: 471

    Deckman and CMAP MAX 4D

    Nick, not strictly an Expedition issue, but you will know the answer, I bet.
    I am considering moving from CMAP raster product (NT) to the CMAP MAX 4D product (combined rater and vector).  I have read somewhere (Will probably) that Deckman, that necessary interface between B&G WTP and Expedition, cannot read MAX 4D.
    What does that mean for Deckman?  Does that simply mean that a chart image will not show in Deckman but nothing else is affected, or that there are other implications?
    Regards

     

    1/21/2018 2:44 pm  #2

    Nick
    Moderator

    Offline

    Registered: 9/16/2015
    Posts: 3,286

    Re: Deckman and CMAP MAX 4D

    That is correct - Dfw cannot use 4D.

    ​NT is also a vector product.

    ​Of course, you should also think about AusENCs in Australian waters.

     

    1/21/2018 3:42 pm  #3

    DuncanR
    Expert

    Offline

    From: Up and down East Coast Aus
    Registered: 9/16/2015
    Posts: 471

    Re: Deckman and CMAP MAX 4D

    Thanks Nick, as I thought.  Understand about AUSENCs, their deployment will produce the same problem for Dfw.  I was simply wondering if having CMAP raster and vector capability meant that Dfw would retain a chart image.

       •Thread Starter
     

     

    1 of 1

  • Index
  •  » Technical Q&A
  •  »  Deckman and CMAP MAX 4D

    • Board footera

     

    Powered by Boardhost. Create a Free Forum




    Check out RaceData for iOS and Android. Expedition data in the palm of your hand, or on your wrist! RaceData

    Interested in advertising here? Over one thousand active navigators and Expedition users visit this forum. Click here to contact the administrator.