Expedition Navigation Software 
1 of 1- gamsberry
- Expert
Offline - From: Seattle
- Registered: 9/17/2015
- Posts: 18
Expedition silently terminates on startup
I've run into an issue during the annual hardware & software update. Expedition starts, brings stripchart up and then silently terminates. It only does this when the Actisense NGT-1 N2K USB network interface is plugged in. If I start Expedition and plug the NGT-1 in after everything works correctly. I removed & re-installed the antisense driver. I ran the Expedition repair install process. I couldn't find any obvious errors in any of the expedition log files. Any suggestions on where to look for clues ?
- platform: Intel NUC 5i3RYB
- Expedition 4D 10.7.13
- Windows 10 - current on patches as of 12/30
- NGT-1 is V2.12 firmware (current).
System changes:
- replaced boot ssd with larger (500gb M.2)
- added memory (to 16GB)
- added internal backup SSD (120GB)
- windows 10 auto patch to current
- Expedition upgrade to 10.7.13
- New expedition license key triggered by hardware changes.
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: Expedition silently terminates on startup
We did find a crash in a NMEA 2000 AIS message handling a week or two ago. This is now fixed in 10.7.14.
So, this updating Exp could be a first good step.
- gamsberry
- Expert
Offline
- From: Seattle
- Registered: 9/17/2015
- Posts: 18
Re: Expedition silently terminates on startup
I'll give that a try. Thanks ! There is a Vesper XB8k on the network.
Update: 10.7.14 solved the problem
Last edited by gamsberry (1/05/2018 7:29 pm)
- •
Thread Starter