Expedition Navigation Software 
1 of 1- birger
- Expert
Offline - From: Oslo, Norway
- Registered: 5/05/2016
- Posts: 27
H5000 & expedition BSP glitch using websockets
Hi,
I se random 0 boatspeed in expedition. I have upgraded expedition to 10.6.10.
I just uppgraded to a H5000 hercules system on my boat. I am using my existing paddlewheel and wane using N2K, It all works great on my jumo displays. No problem in the data pages in H5000, but in expedition it comes out with 0 between every 5 or 10 seconds, This makes calibration and using expedition really hard as a lot of calculated data is based on BSP, and all laylines jump on and off.
i have h5000 conneced with ethernet cable to laptop, and actisense using usb.
anyone expedienced any similar things?
kind regards
Birger
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: H5000 & expedition BSP glitch using websockets
I would suspect you have a second bsp input into Exp or you are also telling Exp to calibrate the bsp.
- birger
- Expert
Offline
- From: Oslo, Norway
- Registered: 5/05/2016
- Posts: 27
Re: H5000 & expedition BSP glitch using websockets
I have just set expedition to calc set and tide... i also have turned off all the stuff from the actisense...
I am using actisense to transmit data, so i have switched off all data from the actisence....
/B
- •
Thread Starter- birger
- Expert
Offline
- From: Oslo, Norway
- Registered: 5/05/2016
- Posts: 27
Re: H5000 & expedition BSP glitch using websockets
@nick - you where absolutely right. The actisense had bsp as well. Now it works like a charm 
Thanx B
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: H5000 & expedition BSP glitch using websockets
Super!