Expedition Navigation Software 
1 of 1- voodoomatz
- Expert
Offline 
- Registered: 6/24/2017
- Posts: 55
No Pol5[or 6, 7, 8] available in dropdown
Hi all,
After a clean install of 10.6.1 I cannot find Pol5[or 6, 7, 8] targets in the dropdown to send to H5000 or to select for an alternating channel. In the past I used Pol5 to output target forestay load to a B&G remote channel. I have the polar file loaded up but Pol5 simply doesn't show in the dropdown box. Is this an issue with 10.6.1? Any ideas?
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: No Pol5[or 6, 7, 8] available in dropdown
It will be listed as an advanced channel since most people don't need it.
Just select the advanced channels button on the number boxes interface etc
- voodoomatz
- Expert
Offline
- Registered: 6/24/2017
- Posts: 55
Re: No Pol5[or 6, 7, 8] available in dropdown
Thanks Nick, that fixed it!
- •
Thread Starter- TC
- Expert
Offline
- Registered: 9/17/2015
- Posts: 18
Re: No Pol5[or 6, 7, 8] available in dropdown
Hi anyone!
I'm sorry. Forgive me if I'm just having a brain fart, but I can't get these advanced channels in the H-Link Custom output dropdowns!
They come up in the numbers boxes dropdown (not sure where that setting is though). I seem to have forgotten how to send Pol5 Targets to H5000!
What am I missing?
TC
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: No Pol5[or 6, 7, 8] available in dropdown
I see they are called polar 0 to 3 in that list. Will fix.
- TC
- Expert
Offline
- Registered: 9/17/2015
- Posts: 18
Re: No Pol5[or 6, 7, 8] available in dropdown
Thanks Nick for the super quick reply.
So for the moment I'll use
Pol0 = Pol4
Pol1 = Pol5
Pol2 = Pol6
Pol3 = Pol7
Thanks again!