Expedition Navigation Software 
1 of 1- colcam
- Member
Offline - Registered: 7/26/2016
- Posts: 2
Stripchart starts but doesn't register
I start Stripchart automaticly when starting Expedition, but no data is registered - anything have to be turned on in addition to starting the Application itself ? I am using the stripchart file from Northu webinar with data like bsp, target speed, TWs, heel etc.
Otherwise running expedition Connected to a H5000 system by an Actisense NMEA2000 - USB. The data comes up in Expedition / number boxes.
Any ideas anyone ?
- ZeeZee
- Expert
Offline
- Registered: 3/30/2016
- Posts: 321
Re: Stripchart starts but doesn't register
Check if under Settings-User the logging is enabled for your boat.
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Stripchart starts but doesn't register
Logging shouldn't matter.
Make sure you have select boat 0 for both number boxes and the stripcharts.
- Joe Goulet
- Expert
Offline
- From: Fort Lauderdale, FL USA
- Registered: 9/16/2015
- Posts: 83
Re: Stripchart starts but doesn't register
Hello Nick,
I don't know how to make the boat 0 selections you described. The only selection I have ever made concerning boat 0 concerned "Boat logging and name" or else was related to "Boat tracking".
Last edited by Joe Goulet (4/05/2017 3:34 pm)
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Stripchart starts but doesn't register
When you set up a number box or aStripchart, one of the options is for the boat. For most people, this should be left as zero.