ExpeditionExpedition Navigation Software

You are not logged in. Would you like to login or register?



2/07/2026 10:53 am  #1


LOG STOPPED

Hi all!
I’ve been having an issue lately — it’s the third time today — related to the log. Exp is working fine, all data is being received from the instruments and the other connections, but when I review the log it’s incomplete. For some reason, Exp stopped logging in the middle of the race. There’s no visible onboard network problem, laylines working all the races......., etc.
Is anyone else experiencing this issue?

 

2/08/2026 1:57 pm  #2


Re: LOG STOPPED

Have you looked in Expedition's System/ error logs? 

Exp may log an error if it can't open the file.

 

2/08/2026 11:57 pm  #3


Re: LOG STOPPED

No files at error folder......
Main changes to EXP and n2k net:
-Increased logging freq to 2Hz
-Added a second ACT NGT1 ( different source node) to n2knet to receive AIS data and GPS data direct to exp.
 

Last edited by gonzgo (2/09/2026 12:10 am)

     Thread Starter
 

2/10/2026 8:30 am  #4


Re: LOG STOPPED

solved!

     Thread Starter
 

2/10/2026 10:27 am  #5


Re: LOG STOPPED

gonzgo wrote:

solved!

How?


:::Campbell Field::::::www.fieldyachting.com:::
 

Yesterday 10:37 am  #6


Re: LOG STOPPED

At least for now…From my point of view, after uninstalling the second NGT1 (which was used for GPS, AIS, and sending waypoints to the autopilot), all the “fast packet” errors on the network disappeared. When both units were installed, some sensors didn’t work properly (Cyclops gateway, YD engine data, etc.), with small micro‑freezes here and there. I imagine exp must have been quite frustrated........The primary NGT1 is the one used to connect the Processor to the N2K network.

 

     Thread Starter
 

Board footera

 

Powered by Boardhost. Create a Free Forum




Check out RaceData for iOS and Android. Expedition data in the palm of your hand, or on your wrist! RaceData

Interested in advertising here? Over one thousand active navigators and Expedition users visit this forum. Click here to contact the administrator.