Hi,

I just noticed this thing:

I have an offshore course active, I set p and s and then add a first mark from bearing and distance.

why expedition use P and not S as reference point of axis?

usually race commite use it's position and sometimes windward mark ribman adjust it to the centre of the line, but not on p position.

​if I set a w/l course the axis point it is correct, it is S and not P

I run two simulation,

1) put a p and s point, it is a large starting line, around 700 mt and than set the first mark with bearing 90° and distance 1 nm.
 
I attatched here some screenshot.



2) same P and S position I created a W/L course, bearing 90, distance 1NM
WM position is correct with reference point of axis S,

also if I choose L above P, wm WM is in correct position 

it is a little bug for 1?