Expedition Navigation Software 
1 of 1- us7070
- Expert
Offline - Registered: 12/06/2017
- Posts: 260
Not Getting Set and Drift From Actisense
For some reason, I do not get set and drift over actisense. It is visible on H5000 displays, so it is being calculated by H50000
If i look at N2K pgn's, Rx 129291 set and drift is checked.
If i look a the raw data, i do not see set and drift.
I am having expedition do the calculation, but i would like to figure out what is wrong with my Actisense setup.
any ideas?
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Not Getting Set and Drift From Actisense
If it isn't in the raw data, then it isn't a problem with the Actisense.
- us7070
- Expert
Offline
- Registered: 12/06/2017
- Posts: 260
Re: Not Getting Set and Drift From Actisense
One reason I thought it might be the actisense, is because the zeus has set and drift - so i guessed it was on the n2k network
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Not Getting Set and Drift From Actisense
It should be 130577.
I am a little surprised if the displays have to calculate it, but maybe H5 is sending it in a custom PGN.
- Astolfo
- Expert
Offline
- From: Seattle, WA USA
- Registered: 8/12/2022
- Posts: 25
Re: Not Getting Set and Drift From Actisense
I would check the Actisense config using their NMEA reader.
I have a filed bug with them because the NTG/NGX can randomly lose/corrupt their configuration on power-off. It is a bug that happens randmly, but they were able to see it happening in my devices live and were able to repro on their lab.
Probably fixed on the NGX, but not in the NTG as there are not many compliants.
Last edited by Astolfo (6/14/2024 12:49 pm)