Expedition Navigation Software 
1 of 1- us7070
- Expert
Offline - Registered: 12/06/2017
- Posts: 260
Problem with Actisense NGT-1 Settings: Source reverts to "All"
I have been having an issue with BSP zeroing out on the log: every 20-30 seconds, i get a few 1-second 0 values.
It's pretty noticeable in strip chart.
When I look in Actisense settings > Sources.., I see that "All" is selected for BSP source, port and starboard.
I usually select "B&G H5000 CPU"
I think that if it will stay at H5000 CPU, I won't get the zeros.., but after a while, it just reverts to "All".
Additionally.., all the sources are usually at "All", and if I try and select,, say 9-axis compass instead of "All".., BSP instantly changes back to "All" as soon as I close the window, and I get the occasional zeros in BSP again.
I have the latest actisense drivers
Any ideas?
Thanks
Last edited by us7070 (5/20/2024 2:08 pm)
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Problem with Actisense NGT-1 Settings: Source reverts to "All"
I can replicate that. Will fix just now.
- us7070
- Expert
Offline
- Registered: 12/06/2017
- Posts: 260
Re: Problem with Actisense NGT-1 Settings: Source reverts to "All"
thanks!
- •
Thread Starter- us7070
- Expert
Offline
- Registered: 12/06/2017
- Posts: 260
Re: Problem with Actisense NGT-1 Settings: Source reverts to "All"
I just noticed 12.0.6
does that have the fix?
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Problem with Actisense NGT-1 Settings: Source reverts to "All"
I had just posted that when I saw your post.
See the version history.
- WoobaGooba
- Expert
Offline
- Registered: 1/24/2016
- Posts: 101
Re: Problem with Actisense NGT-1 Settings: Source reverts to "All"
I had the same issue with sources going back to All whenever any one of them was edited and saved. Can also confirm that latest sw fixes the issue. Thanks!
Last edited by WoobaGooba (5/27/2024 5:55 pm)