Expedition Navigation Software 
1 of 1- DuncanR
- Expert
Offline - From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 470
Deckman and CMAP MAX 4D
Nick, not strictly an Expedition issue, but you will know the answer, I bet.
I am considering moving from CMAP raster product (NT) to the CMAP MAX 4D product (combined rater and vector). I have read somewhere (Will probably) that Deckman, that necessary interface between B&G WTP and Expedition, cannot read MAX 4D.
What does that mean for Deckman? Does that simply mean that a chart image will not show in Deckman but nothing else is affected, or that there are other implications?
Regards
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: Deckman and CMAP MAX 4D
That is correct - Dfw cannot use 4D.
NT is also a vector product.
Of course, you should also think about AusENCs in Australian waters.
- DuncanR
- Expert
Offline
- From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 470
Re: Deckman and CMAP MAX 4D
Thanks Nick, as I thought. Understand about AUSENCs, their deployment will produce the same problem for Dfw. I was simply wondering if having CMAP raster and vector capability meant that Dfw would retain a chart image.
- •
Thread Starter