Expedition Navigation Software 
1 2 Jump to
- DuncanR
- Expert
Offline - From: Up and down East Coast Aus
- Registered: 9/16/2015
- Posts: 470
Re: Expedition Mark Range and Bearing through to B&G H5000 dials
All, I'm not sure about this now. I have just successfully brought Expedition Mark Range and Bearing onto B&G H5000 dials through Instruments/GoFree/Custom/Output/External Remote (didn't think to grab a screenshot), then programming the dials through 2x2/Other. Worked fine.
- sparky
- Expert
Offline
- From: Cambridge UK
- Registered: 4/27/2018
- Posts: 245
Re: Expedition Mark Range and Bearing through to B&G H5000 dials
OK - so this seems to address the issue we are having...
I can send Exp Nav DATA (Mark Range, Mark Brearing, etc) but what doesn't seem to work is the H5000 understand the Expedition course/marks/bearings as Navigational data as understand by .
- ThinMan
- Member
Offline
- Registered: 7/01/2020
- Posts: 1
Re: Expedition Mark Range and Bearing through to B&G H5000 dials
I've got Expedition using the Websockets interface connected via Ethernet to the H5000, with a Vulcan 9 chart plotter on the network. All the firmware is current.
This thread has been quiet for two years, but I'm facing the same challenges described by others. Has there been any progress on getting the H5000 to accept Expedition's active waypoint over Websockets?
The Vulcan is installed in the nav station panel and it's a pain to open up and insert an SD card. I'd really like to do my nav planning on Expedition and either send the waypoints to the Vulcan over the network or send the active waypoint to the H5000. Is either of those possible now?
1 2 Jump to