Expedition Navigation Software 
1 of 1- roc
- Contributor
Offline - Registered: 7/05/2016
- Posts: 5
Newbie question on setting up a new course
I set two marks: Kitchen Shoals...Leave to Port; Montauk Light; Sail to mark.
I set to "Active".
Then, when I try to Optimize the route, I just get:
"You need at least two marks or the current position and a mark to optimize a route".
What am I missing?
- Ernie M
- Moderator
Offline
- Registered: 11/05/2015
- Posts: 399
Re: Newbie question on setting up a new course
Make sure the Kitchen mark is green, try using the arrows.... or set another Course as 'active' then go back to KS-Montauk and 'set active'. It wants that first mark (green fill) to be the start. In 'settings'/'Opt Routing' uncheck "optimize from current position and time"
- roc
- Contributor
Offline
- Registered: 7/05/2016
- Posts: 5
Re: Newbie question on setting up a new course
Ernie M wrote:
Make sure the Kitchen mark is green, try using the arrows.... or set another Course as 'active' then go back to KS-Montauk and 'set active'. It wants that first mark (green fill) to be the start. In 'settings'/'Opt Routing' uncheck "optimize from current position and time"
Perfect! Thank you!
- •
Thread Starter