Expedition Navigation Software 
1 of 1- ian mounsey
- Expert
Offline - Registered: 5/22/2022
- Posts: 15
Quick Jump (GO TO) to Lat and Lon
Is there any way to enter a set of LAT/LON coords and move the cursor straight to that location?
It would be very useful for rapid location of Mayday / Nav Warnings etc.
In Navionics this is done with the Search Function.
- Campbell_Field
- Moderator
Offline
- From: UK
- Registered: 9/16/2015
- Posts: 235
Re: Quick Jump (GO TO) to Lat and Lon
ian mounsey wrote:
Is there any way to enter a set of LAT/LON coords and move the cursor straight to that location?
It would be very useful for rapid location of Mayday / Nav Warnings etc.
In Navionics this is done with the Search Function.
Try using a right mouse click and Ping Mark?
:::Campbell Field::::::www.fieldyachting.com:::
- ian mounsey
- Expert
Offline
- Registered: 5/22/2022
- Posts: 15
Re: Quick Jump (GO TO) to Lat and Lon
Thanks Campbell, I looked at that and while it does place a mark it does not reposition the chart and cursor to that point.
- •
Thread Starter- Ernie M
- Moderator
Offline
- Registered: 11/05/2015
- Posts: 411
Re: Quick Jump (GO TO) to Lat and Lon
Ian,
It's a bit clumsy...but
In the User tab with Follow ticked
go to the Playback tab and tick Simulate
Tick Position and enter 41 20n 71 30w then OK
The chart should jump to that location
If you enter the format wrong eg 7120w it won't go anywhere
Ernie