ExpeditionExpedition Navigation Software

You are not logged in. Would you like to login or register?



12/08/2015 7:36 am  #1


Using an alternate Polar chart

When Optimising can I use an alternate polar?
e.g. I have a polar table under  Tab "Pol8"  can I tell the Optimiser to use that rather than the polar table under Tab "Nav"?  If so how?
Thank you

 

12/08/2015 8:25 am  #2


Re: Using an alternate Polar chart

No, you cannot. To run an optimisation on a different polar you would have to load that polar as the Nav Polar.

The optimisation by pol% is a very effective way to test how sensitive routing is to speed differences in a polar.


:::Campbell Field::::::www.fieldyachting.com:::
 

12/08/2015 11:52 am  #3


Re: Using an alternate Polar chart

OK Thanks Campbell, 
Out of curiosity where are those other Tabs used; what are they for?
 

     Thread Starter
 

1/29/2016 12:14 pm  #4


Re: Using an alternate Polar chart

I have two different boats: different 10m wind scaling, different polars, different sail charts.  How best is this handled to avoid changing these settings back and forth? 

 

1/29/2016 1:02 pm  #5


Re: Using an alternate Polar chart

Hello,​
They are used it you want to make a polar of something like keel angle.
Unfortunately, if you want switch between boats, you need to manually select a different polar.
Nick

 

2/18/2016 3:46 am  #6


Re: Using an alternate Polar chart

Andrew Haliburton wrote:

I have two different boats: different 10m wind scaling, different polars, different sail charts.  How best is this handled to avoid changing these settings back and forth? 

Buy a different copy of Expedition ;-)


:::Campbell Field::::::www.fieldyachting.com:::
 

Board footera

 

Powered by Boardhost. Create a Free Forum




Check out RaceData for iOS and Android. Expedition data in the palm of your hand, or on your wrist! RaceData

Interested in advertising here? Over one thousand active navigators and Expedition users visit this forum. Click here to contact the administrator.