Expedition Expedition Navigation Software

You are not logged in. Would you like to login or register?



7/06/2016 11:52 am  #1


Newbie question on setting up a new course

I set two marks: Kitchen Shoals...Leave to Port; Montauk Light; Sail to mark.
I set to "Active".
Then, when I try to Optimize the route, I just get:
"You need at least two marks or the current position and a mark to optimize a route".
What am I missing?
 

 

7/06/2016 12:09 pm  #2


Re: Newbie question on setting up a new course

Make sure the Kitchen mark is green, try using the arrows.... or set another Course as 'active' then go back to KS-Montauk and 'set active'.  It wants that first mark (green fill) to be the start.  In 'settings'/'Opt Routing' uncheck "optimize from current position and time"

 

7/06/2016 12:39 pm  #3


Re: Newbie question on setting up a new course

Ernie M wrote:

Make sure the Kitchen mark is green, try using the arrows.... or set another Course as 'active' then go back to KS-Montauk and 'set active'. It wants that first mark (green fill) to be the start. In 'settings'/'Opt Routing' uncheck "optimize from current position and time"

Perfect! Thank you!

 

     Thread Starter
 

Board footera

 

Powered by Boardhost. Create a Free Forum

Interested in advertising here? Over a thousand active navigators and Expedition users visit this forum. Click here to contact the administrator.