Expedition Navigation Software 
1 of 1- timlemeer
- Contributor
Offline - Registered: 5/23/2022
- Posts: 8
Custom Channels to Triton2
Hi all,
I have Exp connected via a Yacht Devices N2K interface (YDEN) and like to send custom channels to my B&G Triton2's. Is this possible just via this route? Or only to Garmin displays?
I believe I have set up all correctly (on another boat with H5000 is works perfectly via the websocket connection), but do not see the YDEN as device for performance data source on my Triton2's.
I am still running a H3000 performance processor and have linked this via the H5000 Fastnet interface to the network, but unfortunately it is not sending performance data to the bus... The H-Link connection with Exp. works as well, so I do have the data on the GFD/FFD's inside, but not on my N2K displays outside.. 
Many thanks!
Tim
Last edited by timlemeer (4/29/2024 3:26 am)
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,964
Re: Custom Channels to Triton2
It is only for Garmin displays.
The B&G H5000 websocket is different.
You can send custom data over HLink, but I don't knwo what Triton displays do.
- Astolfo
- Expert
Offline
- From: Seattle, WA USA
- Registered: 8/12/2022
- Posts: 25
Re: Custom Channels to Triton2
The Triton 2 will display custom data if you send custom channels to H5000, Triton Edge, Hercules or Hercules WTP processor, under user. I tested all of them and work like as expected and a HUGE step forward from the H3000 GFDs..
I tried with my old H3000, and the Triton2 do not get the data.
The Triton 2 does not have the ability to process any other NMEA 2000 PGNs than the ones listed in the manual.