Expedition Navigation Software 
1 of 1- Solitude
- Contributor
Offline - Registered: 5/13/2023
- Posts: 8
Data from Expedition to nke instruments (through BoxWifi)
My nke system (Box Wifi + Multigraphics) does not seem to receive data from Expedition. 0183 Data is flowing the other way, but how can I get Expedition to send data like information about polar performance, next mark, bearing, range etc. to the nke system? Any special tips / tricks ?
- Campbell_Field
- Moderator
Offline
- From: UK
- Registered: 9/16/2015
- Posts: 235
Re: Data from Expedition to nke instruments (through BoxWifi)
If Expedition is not receiving data then the communications are not set up correctly.
You can send standard 0183 data to NKE (mark info for example). Perf data via the custom channels.
:::Campbell Field::::::www.fieldyachting.com:::
- Solitude
- Contributor
Offline
- Registered: 5/13/2023
- Posts: 8
Re: Data from Expedition to nke instruments (through BoxWifi)
Thanks again for answering. Guess the communication must be set up correctly since I can read all data from the Nke box in Expedition. My issue is feeding data back to the Nke system - how to do this...
- •
Thread Starter- philippe
- Expert
Offline
- Registered: 3/25/2022
- Posts: 57
Re: Data from Expedition to nke instruments (through BoxWifi)
Hello
I have a NKE system : Box USB Wifi + Multigraphic + NKE sensor and pilote.
Only the GPS is not NKE. It's connected thru NMEA to the NKE topline bus.
I connect the computer with the USB rather than Wifi.
here are my settings in the menu instrument :
and pressing NKE settings :
Expedition send the following information that I find on the multigrafic (after setting in NMEA channel on the NKE box) :
Waypoint.
Polar boat speed (target and so...)
VMG
- Solitude
- Contributor
Offline
- Registered: 5/13/2023
- Posts: 8
Re: Data from Expedition to nke instruments (through BoxWifi)
Thanks philppe,that was really useful. Will check it out!
PO
- •
Thread Starter- Jens_Listrup
- Member
Offline
- Registered: 2/05/2024
- Posts: 3
Re: Data from Expedition to nke instruments (through BoxWifi)
I have installed a Zg100 antenna with heel and pitch sensor. It is visibel on my nmea2k net but the NKE wifibox do not send the data to my expedition. What do I do wrong?
Last edited by Jens_Listrup (5/03/2024 11:18 am)