I have three weather models.  

I then run an ensemble and I get three routes.  When I then run optimize again one of those routes is removed and I get the new route.  If I run ensemble again I don't see 6 routes just three.  

Anybody have any idea what is going on?   This is a new install on new hardware.   Been using Expedition for years and have never seen this before.  Have going through all config and don't see anything that would affect this behavior.

Note I am selecting do not clear old optimal routes when I run new ones.

 

Last edited by robalex117 (8/29/2022 4:34 am)