Expedition Navigation Software 
1 of 1- ErieSailor
- Expert
Offline - Registered: 5/26/2019
- Posts: 21
Great Lakes - Arpege Wave Model
I am experimenting with the Arpege wave model (from Squid) on the Great Lakes. Expedition successfully loads the file, but the contours and shading don't cover the entire basin of each lake. The WX Tooltip has data all the way to the shore.
Any explanation for why this is happening?
Last edited by ErieSailor (12/13/2020 1:49 pm)
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,966
Re: Great Lakes - Arpege Wave Model
I think the 1/2 degree data is just too coarse for such small areas
- ErieSailor
- Expert
Offline
- Registered: 5/26/2019
- Posts: 21
Re: Great Lakes - Arpege Wave Model
Would that account for the contracted display of the data as shown below? I should have added that using the gradient or smoothed mode in Squid displays shading all the way to the shore.
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,966
Re: Great Lakes - Arpege Wave Model
Yes. 30nm resolution doesn't really have enough detail for a lake.
Exp shades between the data points, as you see above.
I just checked Squid and they shade around the data points a little. It doesn't mean there is any data there.
- ErieSailor
- Expert
Offline
- Registered: 5/26/2019
- Posts: 21
Re: Great Lakes - Arpege Wave Model
Thanks.
- •
Thread Starter