Expedition Navigation Software 
1 of 1- fan
- Contributor
Offline - Registered: 3/06/2019
- Posts: 8
Predict Wind EC GRIB not loading and shows no wind at start
So I set up a route in Predict Wind and download all available GRIBS EC, GFS and 8K. They are all based off the same request. I can load GFS and 8K and run routes but the EC says "no wind at start". I tried doing a route for now to see if it resolved and it does not. It does not show any weather loaded at all but the other two are loaded no issue. TIA I tried this over a few different GRIBs to see if it was a corrupted GRIB but it is consistently not loading.
- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: Predict Wind EC GRIB not loading and shows no wind at start
You can't use the EC data - see the thread on this in this forum.
For the other data, does the grib data cover the start are and time?
Do you have a race note to avoid or avoid land option selected at the start?
- fan
- Contributor
Offline
- Registered: 3/06/2019
- Posts: 8
Re: Predict Wind EC GRIB not loading and shows no wind at start
Thanks Nick I was able to find it once you narrowed it down. Kind of limiting since PW Hi Res it out for this race so just GFS
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: Predict Wind EC GRIB not loading and shows no wind at start
What is the race?
- fan
- Contributor
Offline
- Registered: 3/06/2019
- Posts: 8
Re: Predict Wind EC GRIB not loading and shows no wind at start
Cabo
- •
Thread Starter- Nick
- Moderator
Offline
- Registered: 9/16/2015
- Posts: 2,965
Re: Predict Wind EC GRIB not loading and shows no wind at start
Have a look at the NAM option in the NOAA download in Exp.