Expedition Navigation Software / Problem with Actisense NGT-1 Settings: Source reverts to "All"

**Posted by us7070** 5/20/2024 2:07 pm

I have been having an issue with BSP zeroing out on the log: every 20-30 seconds, i get a few 1-second 0 values.

It's pretty noticeable in strip chart.

When I look in Actisense settings > Sources.., I see that "All" is selected for BSP source, port and starboard.
I usually select "B&G H5000 CPU"

I think that if it will stay at H5000 CPU, I won't get the zeros.., but after a while, it just reverts to "All".

Additionally.., all the sources are usually at "All", and if I try and select,, say 9-axis compass instead of "All".., BSP instantly changes back to "All" as soon as I close the window, and I get the occasional zeros in BSP again.

I have the latest actisense drivers

Any ideas?

Thanks

Last edited by us7070 (5/20/2024 2:08 pm)

**Posted by Nick** 5/20/2024 4:05 pm

I can replicate that. Will fix just now.

**Posted by us7070** 5/20/2024 4:18 pm

thanks!

**Posted by us7070** 5/20/2024 5:42 pm

I just noticed 12.0.6
does that have the fix?

**Posted by Nick** 5/20/2024 10:10 pm

I had just posted that when I saw your post.

See the version history.

**Posted by WoobaGooba** 5/27/2024 5:29 pm

I had the same issue with sources going back to All whenever any one of them was edited and saved. Can also confirm that latest sw fixes the issue. Thanks!

Last edited by WoobaGooba (5/27/2024 5:55 pm)