Expedition Navigation Software 
1 of 1
- timlemeer
- Contributor
Offline - Registered: 5/23/2022
- Posts: 8
Sending waypoint to the network via YDEN N2K connection does not work
Hi all,
I am having trouble sending a WP to the network on a N2K connection via the Yacht Devices YDEN interface.
I have an active route, the network connection is working (number boxes work, raw data feed shows info too, etc.) and have selected the appropriate PGN's to send the data. Also, I have clicked the "send data to instruments" button. However somehow the YDEN is not showing up on the N2K network to select as navigantional data (on Triton2's). Also checked the data feed and no navigational PGN is going over the bus, so I must have done something wrong..
All in all I don;t see any incoming data from the YDEN on the bus - it only shows me the data outbound (via the servers and online), so the N2K connections are fine (properly terminated, etc.) and I have no (other) issues with the N2K.
What am I doing wrong? Many thanks for helping me out!
Best, Tim
- Astolfo
- Expert
Offline
- From: Seattle, WA USA
- Registered: 8/12/2022
- Posts: 25
Re: Sending waypoint to the network via YDEN N2K connection does not work
you need to use the "send marks to instruments" and depending which MFD you have the MFD will receive the waypoints. You need to check your MFD's manual and see which PGNs it can Rx.
At one point there was a YT video, it is supper simple.
1 of 1