Expedition Expedition Navigation Software

You are not logged in. Would you like to login or register?

Technical Q&A » Loosing connecting to NMEA UDP feed » 9/28/2019 5:08 am

rogier
Replies: 0

Go to post

I'm using a minplex 3E to send data via UDP to the system but after a while the UDP data stops, when I press reconnect instruments it reconnects straight away all works fine. It looks like expedition times out the UDP connection after a while, because when I use Putty to monitor UDP after 4 hrs it was still runnning where in Expedition it stop after apx 20 minutes. I run the AIS input on this channel aswell. Input is set to NMEA AIS

Any idea. Expedition version installed is : 10.12

Technical Q&A » H3000 XDR Heel and Trim not working » 7/16/2019 2:41 pm

rogier
Replies: 5

Go to post

On the selected NMEA sentence to recieve XDR is on and in the middle section Roll/Heel, Rudder and Trim/Pitch are selected. Data selected in the number boxes is "Heel (Roll)" 
When i had the system connected to a H3000 Hercules Performance using Hlink heel was showing, this is a different boat with a H3000 Hercules so i can't use Hlink but have to use NMEA and I see the sentence coming in just not displaying.

I have enable heel and trim in the H3000_config.txt, not in the H2000_config.txt, could this be related? The input is NMEA not Hlink?
 

Technical Q&A » H3000 XDR Heel and Trim not working » 7/16/2019 1:09 pm

rogier
Replies: 5

Go to post

Setting are H3000 Hydra with XDR sentence on, selected Heel, selected rudder in the XDR section of the nmea setting. Any where else where I need to set the XDR setup?

Technical Q&A » H3000 XDR Heel and Trim not working » 7/15/2019 11:38 am

rogier
Replies: 5

Go to post

I have a H3000 hydra processor  using a serial interface  directly connect to the processor, all works fine expect for the Heel and trim which I can't get to work. It looks like the sentence send out the wrong checksum.  The sentence is $IIXDR,A,-0.2,D,HEEL,A,-0.1,D,TRIM,A,13.0,D,RUDDER*4E recorded straight out oof the processor.  if run it past a checksum check the checksum should be *66 . I can't change this in the H3000,  is their any way of ignoring the checksum or customizing the checksum field for sentence that our out of bound? 

I would realy like to record Heel and trim for performance purpose and be able to send out target heel bank to the CPU.

thx

Board footera

 

Powered by Boardhost. Create a Free Forum

Interested in advertising here? Over a thousand active navigators and Expedition users visit this forum. Click here to contact the administrator.