Expedition Navigation Software 
1 of 1- eclipsemullet
- Expert
Offline 
- From: Cowes, UK
- Registered: 6/12/2016
- Posts: 100
Get H5000 to output desired forestay value
I have a table of TWS and the corresponding Forestay load value.
How do I get the H5000 to output the Forestay value depending on TWS?
Beneteau First 40
B&G H5000
Furuno PG700
Toughbook CF-53
- Campbell_Field
- Moderator
Offline
- From: UK
- Registered: 9/16/2015
- Posts: 212
Re: Get H5000 to output desired forestay value
Go to Polars and select an unused polar i.e. Pol4. Rename it to Tgt_Fsty etc. This will then show as a var Tgt_FstyPol that you can send out the websocket via external channels.
Create the polar respecting the usual polar conventions of any resolution you wish. Note that the output will be a polar number, not a target (vmg) number, so you may want to 'fudge' the TWA entries 5-10 deg each side of what would be a target TWA.
:::Campbell Field::::::www.fieldyachting.com:::
- eclipsemullet
- Expert
Offline
- From: Cowes, UK
- Registered: 6/12/2016
- Posts: 100
Re: Get H5000 to output desired forestay value
Many thanks
Beneteau First 40
B&G H5000
Furuno PG700
Toughbook CF-53
- •
Thread Starter